It was time to change out the air filter that was on the 05 when I bought it. Never really liked this type of air filter system.
05 Mods & Maintenance
1 reading
Ghost03hemi
761 - 780 of 1,800 Posts
Joined
·
19,751 Posts
Looking at how I'm going to install the braided fuel lines. Want the fuel lines to be easily connect/disconnected at the front of the intake manifold. Installing the fuel pressure regulator between the brake master cylinder and the battery. The same place where it was at on the 03. Liked it there. It was easy to read the fuel gauge while setting the fuel pressure.
Joined
·
19,751 Posts
With the Hellcat fuel pump. -06 AN Jegs Pro-Flow 200 series s/s braided hose will slide onto the barbed plastic tube on the fuel pump. Going to use a high quality hose clamp to hold and seal the hose in place. The pic on the bottom is a comparison of a -6an fitting to the pump barb tube.
Joined
·
19,751 Posts
Joined
·
20,323 Posts
Stuff like that makes me nuts...
Joined
·
19,751 Posts
Went ahead and installed all of the NGK 5701 spark plugs. Installed one of the used NGK 5701 plugs (that fired good) up front of the engine on a waste spark plug wire. Started up the truck, she's running good. :thumb::thumb::thumb: Once the new NGK 5701 plug shows up, will install it then. Will take her around the block (2nd gear only) tomorrow just to make sure she running better. Have to make arrangements for the truck to get flat bedded to Aamco for the trans relearn. Back on track. :dance:
PS. Going to wait till after the trans relearn and some driving around on the street before modding the fuel system. Have to order a few more fuel system parts anyhow.
PS. Going to wait till after the trans relearn and some driving around on the street before modding the fuel system. Have to order a few more fuel system parts anyhow.
Joined
·
19,751 Posts
Cruised her around the block in 2nd gear and she's running good. :thumb::thumb:
Now, just have to get scheduled for a flatbed tow truck and trans relearn.
Now, just have to get scheduled for a flatbed tow truck and trans relearn.
Joined
·
20,323 Posts
Thats a good find...
Joined
·
19,751 Posts
Which tool?
Joined
·
19,751 Posts
Have you contacted them to see if it will reset trans parameters?
yes they told me that it will.
Joined
·
19,751 Posts
Does it show the cvi numbers?
I would only trust it if Clint said, it does reset the trans cvi... You can buy it and test it out Mark.
I would only trust it if Clint said, it does reset the trans cvi... You can buy it and test it out Mark.
Joined
·
716 Posts
This procedure worked on my 04. Turn key to run position, wait till all the warning chimes stop, slowly press the footfeed all the way to the floor, then slowly let back up. Turn key off. Now you have reset the throttle pedal. Noticed a little better response.
Joined
·
20,323 Posts
I first noticed a fresh tune settling in quicker back when I was tuning the 03 pcm. During a moment of frustration I stromped the throttle, and ran it up through a gear. Afterwards I noticed the tune had settled in. So after that I did the throttle set with the ignition on and engine off.
Joined
·
19,751 Posts
Once the trans relearn is done, will try out the throttle set. :thumb:
Joined
·
19,751 Posts
Might have to try this. Been having a scheduling an appointment problem with Aamco for the relearn. They're very busy. Or, maybe they want more money for the relearn...
Joined
·
19,751 Posts
My daughter Sydney is officially graduated from college! :dance::dance::dance::dance:
Might be able to put some money in the savings account in about six to eight months... :ermm:
Might be able to put some money in the savings account in about six to eight months... :ermm:
761 - 780 of 1,800 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
