[weldedhemi]

ok fellers, if you're ready i'll start a 'GROUP BUY' for the srt 10 inserts.
i've got the mounting hardware figured out and mr HEMI PUP is getting me the artwork for the 'skull insert'.

 

[weldedhemi]

quote:Originally posted by Daytona5514:
Is it going to attach to the six clips that are already in the opening and if so have you seen one attached and are the clips real visible. THANKS

it attached with either 2 or 3 mounting studs, and has spacers that keep the insert from contacting the paint.
this is a replacement, not a bolt over.

 

[GoManGo]

I take one of the skull inserts

 

[weldedhemi]

newest design from mr HEMI PUP.
it's got more metal in the corners where the mounting studs go.

 

[Guest]

Looks good Bob.

 

[weldedhemi]

FINALLY!

GROUP BUY AT MOE'S on SRT-10 inserts.
http://moesperformance.com/.
thanks,
bob

 

[Guest]

Ok Bob, which one do I need to order for the skull design. It say HTC-1 on the pic, but there isn't an HTC-1 under the drop down order menu.

 

[weldedhemi]

duane, man thanks for pointing that out.
i think the webmaster mislabled it 'dtc' i'll have him fix that.
thanks again,
bob

 

[Guest]

No problem Bob.

Got my traction bars back yesterday and the decals for them came in yesterday too. Just ain't had time to put them back on yet. They are going to look sweet as candy when I get them on though

 

[weldedhemi]

cool duane, if they're the same color as your intake they'll look great!
that's a nice intake you sell.

 

[Daytona1368]

Thanx Bob. Just ordered mine.

 

[weldedhemi]

Thanks Daytona1368, I've got you down for the 'billet' style.
thanks again,
bob

 

[Guest]

Look'n for srt10 custom billet insert with Daytona logo. Who can make one up. ty Mike

 

[HEMI-PUP]

Hey Mike, can you be more specific about the Daytona logo you refer to? Can you post a pic?

Thanks: Pup

 

[Guest]

Only way you could do that is with a solid insert, because the length of the lettering would make it impossible to laser out and still be legible.

 

[Guest]

here ya go pup. Daytona logo for the billet insert. ty mike This message has been edited. Last edited by: MrHemi, document.write(''+ myTimeZone('Tue, 13 Mar 2007 04:28:51 GMT-0700', '13 March 2007 07:28 AM')+''); 13 March 2007 07:28 AM

 

[Guest]

Nice logo, but no way it will fit into that insert hole unless it is a solid piece with a decal or something on it. Barely room enough to squeeze in 3 flat bars.

 

[HEMI-PUP]

semo03hemiram is correct. This one, like any can be custom made but would take a lot of custom hand work and cost a fortune.

Here is a rough draft:

Pup

 

[Guest]

The Ram Air part wouldn't be too difficult, but putting the Daytona Hemi in there would be really hard unless you used a decal.

 

[HEMI-PUP]

I'm not the sharpest knife in the drawer, but if the insert is a "non-functional" insert, this can be done. If it's functional, it can be done in pieces.

Pup