Hemi Truck Club banner
1 - 6 of 6 Posts

Proud Canadian
Joined
120 Posts
Discussion Starter · #1 ·
Does anyone know if there are any longtube D-port headers that will fit a 2004 1500? I am not sure if there are any clearance issues with headers for the cars or later model trucks. It is way overdue for me to address the port/flange mismatch.
 

Administrator
Joined
17,916 Posts
I believe they for with a little bending on the bottom pipes or the complete setup. Chris did this same thing awhile back and his hit on something I just can鈥檛 seem to find it.
 

Proud Canadian
Joined
120 Posts
Discussion Starter · #3 ·
which headers did he use? the steering linkage and UCA mounts are my obvious concerns, but I'm assuming car headers would fit tighter to the block/trans?
 

Proud Canadian
Joined
120 Posts
Discussion Starter · #5 ·
I don鈥檛 recall but he had to bend and beat a little I know that

which headers did he use, and on which year/configuration of truck?
 

Administrator
Joined
17,916 Posts
Ok the headers were from a power wagon that I had at my house lol. The headers I think were custom made for the 6.1 heads that were on the truck stroker motor.
 
1 - 6 of 6 Posts
Top