Hemi Truck Club banner
1 - 20 of 603 Posts

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #1 ·
The new engine....in time I will have more specs.
 

Attachments

·
Greg
Joined
·
19,974 Posts
Everyone gets excited when new parts show up. What pistons are those?
 

·
Greg
Joined
·
19,974 Posts

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #6 ·

·
Greg
Joined
·
19,974 Posts

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #8 ·
here's some of the block work that will never be seen look at before and after treatment in the lifter oil return area in the valley.
 

Attachments

·
Greg
Joined
·
19,974 Posts
The cross hatch pattern is great for oil retension. Good attention to detail. You have a nicely prepared engine. Well done.
 

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #10 ·
Check out the parts after some massaging:smitten:GFBP Go For Broke performance
 

Attachments

·
Greg
Joined
·
19,974 Posts
Mark, that is looking really good! With the custom cam it should be a beast. When do you think you will be up and running?
 

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #12 ·
Mark, that is looking really good! With the custom cam it should be a beast. When do you think you will be up and running?
I should have the engine in my hands by the end of the week ... I could not be any more excited if it weren't for the birth of my children this would be Tops on my list.:dance:
 

·
Greg
Joined
·
19,974 Posts
I completely understand, starting a new motor is exciting.
 

·
Greg
Joined
·
19,974 Posts
Sweet, good luck..
 

·
Mark G Senior Member
Joined
·
1,942 Posts
Discussion Starter · #19 ·
Finally its up and running.... With some borrowed parts and minus the turbo for now. Thank you Stu and Greg this never would have happened this soon. Tomorrow the flat bed takes it to the transmission shop for a tranny relearn. And to make matters even worse I am moving on Thursday! But very happy to have it running!:dance:
 
1 - 20 of 603 Posts
Top