Hemi Truck Club banner

no pedal

1K views 2 replies 3 participants last post by  bud2 
#1 ·
Hello, I have 2005 ram 1500 4 x 4 5.7 4 abs.
I replaced the calipers up front new brake lines and master cylinder.
I bench bleed the master cylinder and then the hole system but get no pedal, it falls to the floor.
with the engine off I get a little pedal but will fall to floor in a few seconds.
I get no pedal at all with the engine running.
I bleed the ABM module with no change.

I am at a loss as to what I can do.

I did install another master cylinder, that did not help.

Can anyone help

Regards,

Leon
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top